The kit contains the parts you need at the barrel or tank of your gravity feed drip system with a water pressure of 30 psi or less (you will need to add a pressure regulator if the pressure is greater than 30 psi). The kit includes a bulkhead fitting for your water barrel or tank. Drill a 1-3/16” hole on a flat or near-flat surface of the barrel or tank. The thick washer will seal on slightly curved surfaces. For cold water use only.
The filter will protect your drippers from debris that may clog your drip system. The FB20 adapter at the outlet fits our T2100 tubing and/or our DL4100 heavywall dripline with an inside diameter of .520 inch (not included). Add tubing and/or dripline as needed to extend your new drip system to your garden. Use non-pressure compensating drippers or dripline for gravity systems with less than 10 psi pressure.
See our article on gravity feed drip systems for more information here http://www.dripirrigation.ca/HowTo_Gravity.asp
See the large photo below to view kit contents.
Please review these other products: